8. STATUS DISPLAY
133
8.2
Configuring Error Detection Settings
To configure the error detection settings, use F•5 STATUS SETUP.
When error detection is set to ON, the following actions are performed when an error occurs.
• Counts errors on the status display.
• Displays errors in the event log of the status display
• Displays “ERROR” in the upper-right of the display.
• Transmits a signal from the alarm output remote terminal
8.2.1
Error Setup 1
Use the ERROR SETUP1 tab to configure error detection settings for SDI signals.
STATUS
→
F•5
STATUS SETUP →
Figure 8-2 ERROR SETUP1 tab
●
Error Counter
Sec:
Errors are counted in units of seconds. Even if multiple errors occur within the
same second, only a single error is counted.
Field:
Errors are counted in units of fields (frames). Even if multiple errors occur
within the same field (frame), only a single error is counted.
●
TRS Error
Select whether to detect TRS Pos and TRS Code errors.
OFF / ON
●
Line Number Error(Except SD)
Select whether to detect line number errors. This setting is valid when the input signal is
not SD.
OFF / ON
Summary of Contents for LV 5480
Page 15: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 7 SCALE UNIT HDV SDV SCALE UNIT HD SD SCALE UNIT 150 ...
Page 38: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 30 COLOR MATRIX XYZ COLOR MATRIX GBR COLOR MATRIX RGB ...
Page 98: ...5 PICTURE DISPLAY 90 STATUS INFO ON Figure 5 34 Turning the information on and off ...