8. STATUS DISPLAY
138
●
Gamut Error
Select whether to detect gamut errors.
ON / OFF
●
Gamut Upper
Set the gamut error upper limit. An error occurs when the input signal level exceeds the
specified value.
In the 5-bar GBR display, levels that are greater than or equal to the specified value are
displayed in red.
90.8 - 109.4 %
●
Gamut Lower
Set the gamut error lower limit. An error occurs when the input signal level goes below the
specified value.
In the 5-bar GBR display, levels that are less than or equal to the specified value are
displayed in red.
-7.2 - 6.1 %
●
Area
Specify the percentage of the active picture area over which errors must occur to be
recognized as an error. You cannot configure this setting when Gamut Error is set to OFF.
0.0 - 1.0 - 5.0 %
●
Duration
Set the number of consecutive video frames over which errors must occur to be recognized
as an error. You cannot configure this setting when Gamut Error is set to OFF.
1 - 60 Frames
●
Composite Gamut Error
Select whether to detect composite gamut errors.
ON / OFF
●
Setup
Select the setup level to add when converting component signals to composite signals.
0%:
No setup level is added.
7.5%:
A setup level of 7.5 % is added.
Summary of Contents for LV 5480
Page 15: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 7 SCALE UNIT HDV SDV SCALE UNIT HD SD SCALE UNIT 150 ...
Page 38: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 30 COLOR MATRIX XYZ COLOR MATRIX GBR COLOR MATRIX RGB ...
Page 98: ...5 PICTURE DISPLAY 90 STATUS INFO ON Figure 5 34 Turning the information on and off ...