8. STATUS DISPLAY
139
●
Composite Upper
Set the composite gamut error upper limit. An error occurs when the input signal level
exceeds the specified value.
In the 5-bar CMP display, levels that are greater than or equal to the specified value are
displayed in red.
90.0 - 135.0 %
●
Composite Lower
Set the composite gamut error lower limit. An error occurs when the input signal level goes
below the specified value.
In the 5-bar CMP display, levels that are less than or equal to the specified value are
displayed in red.
-40.0 - 20.0 %
●
Area
Specify the percentage of the active picture area over which errors must occur to be
recognized as an error. You cannot configure this setting when Composite Gamut Error is
set to OFF.
0.0 - 1.0 - 5.0 %
●
Duration
Set the number of consecutive video frames over which errors must occur to be recognized
as an error. You cannot configure this setting when Composite Gamut Error is set to OFF.
1 - 60 Frames
Summary of Contents for LV 5480
Page 15: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 7 SCALE UNIT HDV SDV SCALE UNIT HD SD SCALE UNIT 150 ...
Page 38: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 30 COLOR MATRIX XYZ COLOR MATRIX GBR COLOR MATRIX RGB ...
Page 98: ...5 PICTURE DISPLAY 90 STATUS INFO ON Figure 5 34 Turning the information on and off ...