8. STATUS DISPLAY
163
8.7
Setting the Lip Sync Measurement (SER03)
To show the lip sync measurement screen, follow the procedure below.
By combining a Leader signal generator that supports lip syncing with this instrument, you
can use the lip sync measurement screen to measure the offset between the video signal and
the audio signal that occurs in the transfer route.
Procedure
STATUS
→
F
･
2 SDI ANALYSIS
→
F
･
4 AV PHASE
Figure 8-13 Lip sync measurement screen
As an example, we will show a procedure that uses the LT 4400 (the LT 4400SER01 must be
installed) as the signal generator that supports lip syncing.
1. Turn the LT 4400 lip sync feature on.
SDI SETTING→LIPSYNC to turn this feature on. For details, see the LT 4400 instruction
manual.
2. Send the signal generated from the LT 4400 SDI output connector to the transfer route.
Apply the signal received from the transfer route to the SDI connector of this instrument.
If the output audio is external audio, apply the video signal to the SDI input connector
and the audio signal to the digital audio I/O connector.
3. Select the audio signal.
On the instrument’s AUDIO
→
F•1
MAPPING →
AUDIO MAPPING tab, set the audio
signal to EMB AUDIO (for embedded audio) or EXT AUDIO (for digital audio I/O
connector). For EXT AUDIO, EXTERNAL AUDIO on the AUDIO IN/OUT tab must be set
to INPUT.
Summary of Contents for LV 5480
Page 15: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 7 SCALE UNIT HDV SDV SCALE UNIT HD SD SCALE UNIT 150 ...
Page 38: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 30 COLOR MATRIX XYZ COLOR MATRIX GBR COLOR MATRIX RGB ...
Page 98: ...5 PICTURE DISPLAY 90 STATUS INFO ON Figure 5 34 Turning the information on and off ...
