8. STATUS DISPLAY
184
●
Selecting the Dump Mode
You can use F•2 DUMP MODE to set the dump mode to HEX (hexadecimal display) or
BINARY (binary display).
●
Selecting Which Signal to Display
When the input signal is not SD, you can use F•3 Y/C SELECT to set the data to display
to that of the Y signal or the C signal.
●
Selecting Which Stream to Display
When the input signal is 3G-B, you can use F•4 STREAM SELECT to set the data to
display to STREAM1 or STREAM2.
●
Selecting the Displayed Information
When the input signal is multi link, you can use F•5 LINK to select displayed information.
When the input signal is 12G, you can use F•5 SUB to select displayed information.
Summary of Contents for LV 5480
Page 15: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 7 SCALE UNIT HDV SDV SCALE UNIT HD SD SCALE UNIT 150 ...
Page 38: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 30 COLOR MATRIX XYZ COLOR MATRIX GBR COLOR MATRIX RGB ...
Page 98: ...5 PICTURE DISPLAY 90 STATUS INFO ON Figure 5 34 Turning the information on and off ...