9. EYE PATTERN DISPLAY (SER02/SER09)
193
9.7
Configuring Eye Pattern Display Settings
To configure eye pattern display settings, press F•3 EYE SETUP on the EYE menu.
This appears when F•2 MODE is set to EYE.
EYE
→
F•3
EYE SETUP →
Figure 9-8 EYE SETUP menu
9.7.1
Adjusting the Gain
To adjust the eye-pattern gain, follow the procedure below.
Procedure
EYE
→
F•3
EYE SETUP →
F•1 GAIN VARIABLE: CAL / VARIABLE
Settings
CAL:
The eye pattern is shown without gain.
VARIABLE: The eye pattern is shown with the specified gain (x0.50 to x2.00). The gain
value appears in the upper right of the screen.
Turn the function dial (F•D) to adjust the gain. Press the function dial (F•D) to
return the setting to its default value (x1.00).
9.7.2
Selecting the Sweep Time
To select the eye pattern sweep time, follow the procedure below.
Procedure
EYE
→
F•3
EYE SETUP →
F•2 SWEEP: 2UI / 4UI / 16UI
Settings
2UI:
Two cycles of the eye pattern are shown.
4UI:
Four cycles of the eye pattern are shown.
16UI:
Sixteen cycles of the eye pattern are shown.
Summary of Contents for LV 5480
Page 15: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 7 SCALE UNIT HDV SDV SCALE UNIT HD SD SCALE UNIT 150 ...
Page 38: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 30 COLOR MATRIX XYZ COLOR MATRIX GBR COLOR MATRIX RGB ...
Page 98: ...5 PICTURE DISPLAY 90 STATUS INFO ON Figure 5 34 Turning the information on and off ...