5. PICTURE DISPLAY
82
5.6
Focus Assist Display (SER04)
The focus assist display makes it easy to verify the focus by highlighting the image according
to the amount of detected edges.
To configure the focus assist settings, press F•5 FOCUS on the PIC menu.
This menu item does not appear when SIZE is set to FULL FRM.
Reference SIZE
5.8.1, “Selecting the Display Size”
PIC
→
F•5 FOCUS
→
Figure 5-26 Focus assist display
5.6.1
Selecting the Display Size
To select the picture display size, follow the procedure shown below.
See section 5.8.1, “Selecting the Display Size.”
Procedure
PIC
→
F•5 FOCUS
→
F•1 SIZE: FIT / REAL / X2
5.6.2
Turning Focus Assist On and Off
To turn the focus assist display on and off, follow the procedure below.
Procedure
PIC
→
F•5 FOCUS
→
F•2 FOCUS ASSIST: ON / OFF
5.6.3
Selecting the Detection Sensitivity
When F•2 FOCUS ASSIST is set to ON, to select the edge detection sensitivity, follow the
procedure below.
Procedure
PIC
→
F•5 FOCUS
→
F•3 EDGE SENSITIVE: LOW / MIDDLE / HIGH / V-HIGH / U-HIGH
Summary of Contents for LV 5480
Page 15: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 7 SCALE UNIT HDV SDV SCALE UNIT HD SD SCALE UNIT 150 ...
Page 38: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 30 COLOR MATRIX XYZ COLOR MATRIX GBR COLOR MATRIX RGB ...
Page 98: ...5 PICTURE DISPLAY 90 STATUS INFO ON Figure 5 34 Turning the information on and off ...