8. STATUS DISPLAY
175
8.9.4
Displaying Audio Control Packets
To display audio control packets, follow the procedure below.
Procedure
STATUS
→
F•4 ANC PACKET
→
F•1 PACKET ANALYSIS
→
F•3 CONTROL PACKET
Figure 8-23 Audio control packet display
●
Selecting the Display Format
You can use F•1 DISPLAY to set the display format to TEXT (text display) or DUMP
(dump display).
If you select DUMP, the dump display appears, and you can use the function dial (F•D) to
view the entire data. If you press the function dial (F•D), the first data entry is displayed.
●
Selecting the Dump Mode
When F•1 DISPLAY is set to DUMP, you can use F•2 DUMP MODE to set the dump
mode to HEX (hexadecimal display) or BINARY (binary display).
●
Selecting the Group to Display
You can use F•3 GROUP to set the group to display to a group from groups 1 to 4. A
single group in the audio signal consists of four channels.
●
Selecting Which Stream to Display
When the input signal is 3G-B, you can use F•4 STREAM SELECT to set the data to
display to STREAM1 or STREAM2.
●
Selecting the Displayed Information
When the input signal is multi link, you can use F•5 LINK to select displayed information.
When the input signal is 12G, you can use F•5 SUB to select displayed information.
Summary of Contents for LV 5480
Page 15: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 7 SCALE UNIT HDV SDV SCALE UNIT HD SD SCALE UNIT 150 ...
Page 38: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 30 COLOR MATRIX XYZ COLOR MATRIX GBR COLOR MATRIX RGB ...
Page 98: ...5 PICTURE DISPLAY 90 STATUS INFO ON Figure 5 34 Turning the information on and off ...
