9. EYE PATTERN DISPLAY (SER02/SER09)
199
9.7.6
Moving Cursors
To move a cursor, follow the procedure shown below to select a cursor. Then, move the
cursor by turning the function dial (F•D). Triangles appear on both ends of the selected
cursor.
You can also select a cursor by pressing the function dial (F•D). Each time you press the
function dial (F•D), the selected cursor switches from REF, to DELTA, to TRACK, and then
back to REF.
Procedure
EYE
→
F•3
EYE SETUP →
F•4
CURSOR/TRIGGER →
F•4 FD VAR: REF / DELTA /
TRACK
Settings
REF:
The REF cursor (yellow or light blue) is selected.
DELTA:
The DELTA cursor (purple or green) is selected.
TRACK:
The REF cursor and DELTA cursor are both selected.
9.7.7
Selecting the X-Axis Measurement Unit
When F•2 XY SEL is set to X, to select the X-axis cursor measurement unit, follow the
procedure below.
Procedure
EYE
→
F•3
EYE SETUP →
F•4
CURSOR/TRIGGER →
F•3 X UNIT: sec / Hz / UIp-p
Summary of Contents for LV 5480
Page 15: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 7 SCALE UNIT HDV SDV SCALE UNIT HD SD SCALE UNIT 150 ...
Page 38: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 30 COLOR MATRIX XYZ COLOR MATRIX GBR COLOR MATRIX RGB ...
Page 98: ...5 PICTURE DISPLAY 90 STATUS INFO ON Figure 5 34 Turning the information on and off ...
