4. CIE DIAGRAM DISPLAY (SER05)
56
4.3
Configuring Line Selection Settings
To configure line selection settings, press F•3 LINE SEL on the VECT menu.
See section 3.3, “Configuring Line Selection Settings.”
4.4
Configuring Cursor Settings
To configure cursor settings, press F•4 CURSOR on the VECT menu.
VECT
→
F•4 CURSOR
→
Figure 4-10 CURSOR menu
4.4.1
Displaying the Chromaticity Diagram Cursor
To display a cursor on the chromaticity diagram, follow the procedure shown below.
You can move the cursor horizontally using the H POS knob and vertically using the V POS
knob. The measured values are shown in the upper right of the display. Press the H POS
and V POS knobs to move the cursor to the following position.
Chromaticity diagram display:
(x, y) = (u', v') = (0, 0)
Color temperature display:
Lower left of the display
Procedure
VECT
→
F•4 CURSOR
→
F•1 CURSOR: ON / OFF
Figure 4-11 Displaying the chromaticity diagram cursor
4.5
Configuring the Display Settings
To configure the display settings, press F•5 DISPLAY on the VECT menu.
See section 3.5, “Configuring the Display Settings.”
Summary of Contents for LV 5480
Page 15: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 7 SCALE UNIT HDV SDV SCALE UNIT HD SD SCALE UNIT 150 ...
Page 38: ...2 VIDEO SIGNAL WAVEFORM DISPLAY 30 COLOR MATRIX XYZ COLOR MATRIX GBR COLOR MATRIX RGB ...
Page 98: ...5 PICTURE DISPLAY 90 STATUS INFO ON Figure 5 34 Turning the information on and off ...
