4. BEFORE YOU BEGIN MEASURING
26
4.4.4
Selecting the Measurement Signal (LV 5838 only)
External audio signals and embedded audio signals cannot be measured simultaneously.
To switch the measurement signal, press the INPUT key on the front panel. During SDI
measurement, hold down the INPUT key to switch the measurement channel.
The signal that is currently being measured is displayed in the upper left of the screen as
follows.
SDI channel A
SDI channel B
AES
Figure 4-11 Selecting the measurement signal
4.4.5
Selecting the Display Mode
The measurement spring has several display modes. To switch the mode, press
F•1
DISPLAY on the mode menu. In 2-screen display mode, you can select the display mode of
each screen separately.
Table 4-2 Selecting the display mode
Display Mode
Description
Reference
METER
Meters are displayed.
LISSAJOU
The Lissajous curves and meters are displayed.
SURROUND
Surround waveforms and meters are displayed.
LOUDNESS
Loudness meters and charts are displayed.
STATUS
Audio status, SDI status (LV 5838 only), event log, and PHY (LV 5838 only)
are displayed.
4.4.6
1-Screen Display and 2-Screen Display
The LV 5837/LV 5838 can display one measurement screen (1-screen display) or two
measurement screens top and bottom (2-screen display).
In 1-screen display, press SINGLE/MULTI to switch to 2-screen display.
In 2-screen display, press
to select the top screen,
to select the bottom screen,
and SINGLE/MULTI to show the selected screen in 1-screen display.
1-screen display
2-screen display
Figure 4-12 1-screen display and 2-screen display
USO
RESTRITO
