6. LV 58SER04 SYSTEM SETUP
20
6.1.4
Selecting an Audio PID
To select the PID of the audio stream that you want to decode, perform the procedure
described in section 6.1.1,
“Semiautomatic PID Selection,” or in section 6.1.2, “Manual PID
Selection,” and then select a PID for a decodable audio stream from among the PIDs listed
in the PMT. The PID for the audio data that you select will be displayed in light blue.
When you select a PID for a PMT in the PID selection display, the PIDs listed in the PMT
appear. Turn
the function dial (F•D) to move the cursor to a PID for decodable audio data.
AUDIO is displayed to the right o
f PIDs for decodable audio data. Press F•4 AUDIO PID
SEL to select the PID of the audio data to be decoded. You cannot select PIDs that do not
have AUDIO displayed to their right, even if you move the cursor to them and press
F•4
AUDIO PID SEL.
• Procedure
SYS
→ F•1 UNIT SETUP → F•1 to F•4 SETUP (select the unit number that corresponds
to the slot that the LV 58SER04 is installed in)
→ F•4 AUDIO PID SEL
6.1.5
PID Display Format
The PID that appears in the unit setup display and various other displays is initially
displayed in hexadecimal (HEX), but you can switch the display to decimal (DEC) by
following the procedure below.
• Procedure
SYS
→ F•1 UNIT SETUP → F•1 to F•4 SETUP (select the unit number that corresponds
to the slot that the LV 58SER04 is installed in)
→ F•6 PID DISP
:
HEX / DEC
HEX
DEC
Figure 6-3 PID display format
USO
RESTRITO
