ENGLISH
WARNING! Be sure to use appropriate
protective gear and unplug unit.
WARNING! Make sure area is well ventilated.
Aligning the pickup tube (FIG. B) The pickup tube
(#15) needs to be aligned in the direction toward
the front of the canister ( FIG. B). This will ensure
you spray as much material as Make sure the
pickup tube is assembled tight in place.
Attaching spray unit to spray gun handle (FIG. C)
Align the marking line on the spray unit with the
icon of unlock, then rotate the spray gun handle
clockwise until stop. Rotate the quick release
lock (#18) and snap onto the hook on the edge of
canister lid.
Liquid material preparation (FIG. D AND D1) Tip:
Make sure the type of material you use can be
cleaned with either mineral spirits or paint thinner
(for oil-based paints) or a warm water and soap
solution (for water soluble paints like latex).
Use drop cloths during pouring, mixing, and
viscosity testing of materials to be sprayed to
protect your floors and anything else in the
spraying area that you wish to remain untouched.
The liquid being sprayed may need to be
thinned (diluted) before starting. When
thinning, use the proper liquid thinner
recommended on the container by the
material manufacturer.
WARNING!: Do not use materials with a
flashpoint higher than 60ºC (140ºF).
A viscosity test cup is provided to determine
the“runout time” of the material being used.
> Before measuring for the proper viscosity, stir the
material thoroughly.
> Dip the viscosity cup into the material being.
> With the cup held over the material container,
measure the amount of time it takes for the being
a constant stream out of the bottom of the cup (70
seconds or less) (FIG. D). This is the “runout time”.
Refer to the thinning table for information on the
thinning required for different materials.
> If material needs thinning, add the appropriate
liquid, thinning material recommended by the
manufacturer (FIG. D1).
> It is possible to spray latex paint with this unit,
however, the required thinning may exceed
material manufacturer’s recommendation. Thin
latex paint so that it runs through viscosity cup
within 70 seconds. The operator should consider
the type of application and final location of the
project when spraying a material that requires
more than 70 seconds to run through the
viscosity cup. Unscrew the quick refill lid (#12)
SET / UP
