ENGLISH
> Remove the o-ring (#14), pickup tube (#15), check
valve (#16), and quick refill lid (#12) from the
sprayer. Clean the parts with the cleaning brush in
the appropriate cleaning solution (FIG. O). Note:
When removing the check valve, twist the check
valve clockwise and then pull it out. (FIG O1).
> Unscrew the tip collar (#3) and remove all the
parts of the spray nozzle (#3,#4,#5,#6,#7.#8) from
the sprayer. Remove the spray tip (#8) from the
sprayer (FIG. P1). Clean all parts with the cleaning
brush in the appropriate cleaning solution (FIG. P,
FIG.P1). Be sure to clean around check valve with
brush (FIG. P INSERT).
> If using water based material, clean the sprayer by
running water through pickup tube inlet as shown
in FIG. Q. If using oil based materials, clean pickup
tube inlet with the appropriate cleaning solution.
Repeat until sprayer is completely clean.
> Dry all parts thoroughly.
> Place a drop of household oil into the inside of the
sprayer from the hole for assembling the spray tip
(FIG. R).
> Reassemble sprayer (FIG. S).
Note: Spray nozzle can only be assembled in one
direction that the notch of the nozzle (#5) must align
with the skirt on spray unit housing (#9). Refer to
FIG. S for proper assembly.
Note: The spray tip must be assembled in the
sprayer with the bumps on the spray tip in vertical
direction Note: Assemble the pickup tube (#15) and
check valve (#16) by firmly pushing them onto the
inlet on the sprayer.
> Put all the accessories back into space.
Use only mild soap and damp cloth to clean the
power unit. Never let any liquid get inside the power
unit; never immerse any part of the power unit into
a liquid.
IMPORTANT! To assure product SAFETY
and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual)
should be performed by authorized service centers
or other qualified service personnel, always using
identical replacement parts. The power unit contains
A washable / reusable flter (#21). Check the flter
before and after each use. If dirty, wash with warm
water and allow to air dry before re-installing or
replace if necessary (FIG. T).
> To check the filter, Unscrew the screws on back
of the filter cover (#22) and remove the filter
cover (#22).
Remove the filter as shown in FIG. T and inspect.
Reassemble the flter and flter cover.
IMPORTANT ! Never operate the power unit
without the filter in place. Debris could be sucked in
and interfere with the function of the power unit.être
MAINTENANCE
