Place the red wire through hole marked with
a square gold pad. Place the blue/black wire
through the circle hole. Red indicates positive
and the other wire is negative.Give yourself a
length of solder, 4 to 6 inches. Then, holding
the solder in one hand and your soldering iron
in the other, use the tip of your iron to heat up
both the exposed wire of the vibration motor
and the gold ring around the hole. Slowly feed
in your solder into this joint until you've made
a solid connection. Viola! One solder joint
complete! Use the sticky back of the vibration
motor to stick it to the board.
04.
Step-By-Step
Assembly Instructions
1.
STEP 1: VIBRATION MOTOR
IT IS IMPORT THAT VIBRATION MOTOR IS
PLACED CORRECTLY OR YOUR BUG WILL
NOT TURN ON.
Blue/Black
Wire
Red Wire
Vibration motor’s
sticky back
Summary of Contents for Jitterbug
Page 1: ......
