Requires: 3 x 1.5V AAA batteries and a Phillips screwdriver
• Batteries should be installed or replaced by an adult.
• The Robot Mouse requires (3) three AAA batteries.
• The battery compartment is located on the back of the unit.
• To install battery, first undo the screw with a Phillips screwdriver and
remove the battery-compartment door. Install batteries as indicated inside
the compartment.
• Replace compartment door and secure with screw.
Battery Care and Maintenance Tips
• Use (3) three AAA batteries.
• Be sure to insert batteries correctly (with adult supervision) and always
follow the toy and battery manufacturer’s instructions.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries.
• Do not mix new and used batteries.
• Insert battery with the correct polarity. Positive (+) and negative (-) ends
must be inserted in the correct directions as indicated inside the
battery compartment.
• Do not recharge non-rechargeable batteries.
• Only charge rechargeable batteries under adult supervision.
• Remove rechargeable batteries from the toy before charging.
• Only use batteries of the same or equivalent type.
• Do not short-circuit the supply terminals.
• Always remove weak or dead batteries from the product.
• Remove batteries if product will be stored for an extended period of time.
• Store at room temperature.
• To clean, wipe the surface of the unit with a dry cloth.
Please retain these instructions for future reference.
2841 STEM Mouse_GUD RVMP.indd 7
2/24/16 1:55 PM
