Lec CU 357, Operating Instructions Manual

10

GB/IE

Electrical connection

The appliance is intended for connection to alternating current. The connection values 

for voltage (V) and frequency (Hz) are given on the nameplate in the cabinet.

Power must be connected via a wall socket with switch. The wall socket should be 

easily accessible.

All earthing requirements stipulated by the local electricity authority must be observed. 

The cabinet plug and wall socket should then give correct earthing. If in doubt, contact 

your local supplier or an authorised electrician.

WARNING

 – This appliance must be earthed

The flexible cord (mains lead) fitted to this appliance has three cores for use with a 

3-pin 13-amp plug. If a BS 1363 (13-amp) fused plug is used, it should be fitted with 

a 13-amp fuse.

IMPORTANT

The cores in this mains lead are coloured in accordance with the following code:

GREEN-AND-YELLOW: EARTH

BLUE: NEUTRAL 

BROWN: LIVE

These colours might not correspond with the colour markings identifying the terminals 

in your plug.

Note:

First connection to the mains.

The appliance provides information about the higher temperature (Hi alarm ) till the 

moment of cooling.

The alarm is signalised by a sound signal and “Hi” caption on the display. 

To cancel the alarm, press any push button. 

Until the moment of cooling, the alarm is repeated every 15 minutes.

Such  an  operating  mode  is  normal  until  the  required  temperature  settings  are 

reached.