www.lec-commercial.co.uk
6
Electrical Connection
This appliance is intended for connection with alternating current. The connection
values for voltage (V) and frequency (Hz) are declared on the name plate in the product.
Power must be connected via a wall socket with a switch. It is strongly recommended
that the wall socket is accessible. The product plug and wall socket should give correct
earthing. If in doubt, please contact your local supplier or an authorised electrician.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
WARNING:
THIS APPLIANCE MUST BE EARTHED
The flexible cord (mains lead) fitted to this product has three cores for use with a 3-pin
13 amp plug. If a BS 1363 (13-amp) fused plug is used it should be fitted with a 13-amp
fuse.
The cores in the mains lead are coloured in accordance with the following code:
Note: These colours may not correspond with the coloured markings identifying the
terminals in your plug.
Do not
push excess mains lead into the compressor compartment.
If it is necessary to change the fuse in a moulded plug and the fuse cover is detachable, it
must be refitted after the fuse has been changed. If the fuse cover is lost or damaged the
plug must not be used until a replacement is obtained.
It is important that the colour of the replacement fuse cover corresponds with the
coloured insert or as indicated in embossed words on the base of the plug. Replacement
fuse covers are available from our Spares department, at the address on the final page of
this manual.
2
GREEN AND YELLOW
- EARTH
BLUE
- NEUTRAL
BROWN
- LIVE
