Leckey Comfee Seat, User Instructions

Loosen the soft touch knob at top rear 
or seat (a).  Insert the headrest bars into 
receivers at top of seat (b).  Adjust to height 
required, tighten knob to secure.

To insert speakers (only if you have ordered 
optional headrest with speakers) open the 
zip at the rear of the headrest. Insert the 
speakers into the 2 x pockets in the lining 
of the headrest. Pull the speakers cable out 
through the rear pocket to connect to your 
device which can be stored in the top pocket 
of the headrest cover.

Be careful not to trap fingers when 
sliding headrest bars into the receivers.

Remove top backrest cushion by pulling 
tabs away from poppers at the rear of the 
backrest.  Align the two holes in lateral 
bracket to the slot in the metal plate at the 
centre of the backrest (a). Align the washer 
between the metal plate and the wood; insert 
screw through the rear of backrest through 
the full assembly (b). Secure with nut at the 
front of the assembly. Note – this is easier to 
attach when the seat is tilted backwards.

Remove seatbase cushion by pulling tabs 
away from poppers underneath the rear 
of the seat and lifting cushion off Velcro 
strips. Feed the 4 pelvic belt straps through 
camlock fittings (a) and clamp to secure.

7.1 Attaching the head 
support with or without 
speakers 

7.2 Attaching the 
Flipaway Chest Laterals 

7.3 Attaching the 4 point 
pelvic belt  

7.4 Attaching the tray

Before you insert the tray, make sure the tray 
lock lever is unlocked (a). Align tray bars with 
the two tray receivers. Push tray into required 
position and secure by pulling the tray lock 
lever at each side away from each tray bar 
(b).

A

A

A

A

B

B

B