p12
Mygo Seat - Size 3 Stander User Manual
Always check the handle
and locking pin are fully
engaged before you place
the child in the seating
system. If the handle is not
engaged properly the seat
unit can come loose and
could cause serious injury
to the child or carer.
First release the safety locking pin at
the front of the seat. To do this pull
the pin out and rotate through 90
degrees. Carefully lift the seat and
place it into the chassis. At the rear
of the underside of the seat you will
see a receiving channel. Place this
securely over the tube towards the
back of the chassis. Pull the handle at
the front of the seat unit up and then
pivot the seat forward and down.
Once the front of the seat is lowered
fully, release the handle and push it
forward to ensure it has fully engaged
on the front tube. Rotate the safety
locking pin so it engages in front of
the handle. If it hits the handle then
the seat is not inserted properly.
Remove and repeat process outlined
above.
9.4 ATTACHING THE
PUSH HANDLE
The push handle is attached to
the Hi-low chassis by inserting the
two lower stems into the receiving
tubes as shown. The push handle
has safety poppers , which need
to be pressed in when inserting the
lower stems. Push the stems in until
the poppers protrude from the other
end of the receiving tubes. Secure
the handle in place by tightening
the locking knobs .
