Mygo Max User Manual
p31
The control box checks the battery level
every 24 seconds, and when the battery
reaches a low limit, then the control box
will give a double-beep every 24 seconds
to indicate that the battery needs
recharging.
This is done in the ”C3-charger”, full
re-charging takes 5-8 hours, depending
on state of charge. To remove the
battery, turn it 90 degrees (right- or left)
to release it from the magnets . The
battery (NiMH-type) can be recharged
from any state of charge without
12.5 CHARGING THE
BATTERY
reducing battery life or battery-capacity.
When connecting the ”C3-charger” to
the mains (100 – 240 V AC), the red
diode lights up continuously and a single
flash in the green diode appear before it
turns off again.
When inserting the battery into the
charger, the green diode starts flashing
with an interval of 1/sec during the
charging process.
When charging is finishing, the green
diode stops flashing and turns on
continuously, the battery is fully charged,
can be removed and is ready for use in
the C3 controller.
Repeated runs at a high rate with heavy
loads, may create overheating inside the
battery – a safety interlock-temperature
sensor will disconnect the power. When
the battery has cooled down to accepted
working temperature the power switch
on automatically.
To secure long lifetime of NiMH batteries,
it is recommended to recharge the
battery at least every 3 months.
Beep signals:
Long beep: Power on (battery inserted)
Two short beeps: Every 24 seconds
(when the system is not in use): =
indicating low battery level, please
recharge.
Two short beeps: When starting the
actuator = low voltage, please change
battery soon, or recharge—the battery
