Lectranator Systems 27315, Installation & Operation Manual

CONFIGURATION 2:

Typical End-of- line Convection Installation (Flow Switch Disabled) 

For 24 Hour  Operation As A "Convection Style" Unit

OXYGEN BUBBLES GENERATED WITHIN THE CELL CAN BE UTILIZED TO CREATE FLOW.  

STEP 1    Disconnect the cell flow switch cable mounted with the cell. Plug the shorting plug 

(included in the convection installation kit) into the back 2-circuit connector 
input (plug closest to wall at bottom of Control Panel). 

STEP 2    Install Convection Kit (per sketch).Cut pipe directly below skimmer and  insert 

                      proper size solvent weld or flex hose tee, connect per diagram below to 
                      second tee / check valve combination on input side of cell assembly. 

FLOW DETECTOR 

WITHOUT A 

CABLE.  

IMPORTANT NOTES: 

1. The cell must be mounted  vertically, with unobstructed free flow through the discharge outlet. This 
allows complete disbursement of gas bubbles generated during purifier production. 

2. Convection illustration depicts a vertical cell (see sketch above) immediately adjacent to the 
discharge supplied by a direct bypass to avoid the flow restrictions of the circulation system. 

3. The flow induced by the rising bubbles disperses the purifier generated into the volume even 
when the pump at rest. Activation of the pump closes a  GRAVITY TYPE ONE WAY CHECK VALVE i n  
the bypass run. 

4. Pipe between the suction tee  and check valve supplied by owner. 

Gravity /flapper style check valves are normally installed 

with the hinge at the top, it is not imperative in this 

application. In fact an inverted position allows the flapper 

to lay open with pump at rest offering absolute minimum 
restriction.  

SUCTION 

PVC OR 
FLEX PIPE 

DISCHARGE 

GRAVITY TYPE 
ONE WAY CHECK               
VALVE 

18 

BYPASS