Lectrosonics Handheld Transmitter, Instruction Manual

HH

LECTROSONICS, INC.

6

Battery Installation

To insert batteries, close the eject lever and insert the 

upper contacts first (closest to the mic capsule). Polar-

ity is marked on the label in the bottom of the battery 

compartment.

Close 

eject lever 

to install 

batteries

To remove the batteries, pull the eject lever outward. 

The battery tips will move outward, making them 

easier to grasp.

Pull eject lever outward to release batteries from contacts

The contacts are very tight to prevent the batteries 

from “rattling” as the transmitter is being handled.

IR Sync

The IR SYNC (infrared sync) port is used with receiv-

ers that offer this feature. Settings stored in the receiv-

er for frequency, step size and compatibility mode are 

transferred to the transmitter via the infrared ports. To 

use this feature, open the housing on the transmitter 

to expose the control panel. Hold the transmitter near 

the receiver (less than 3 feet away) so the IR ports 

face each other. The transfer is triggered by a switch 

on the receiver. The LCD on the transmitter will display 

a message confirming that the settings were success-

fully transferred, or an error message that identifies the 

problem that occurred.

IR Sync

 COMPAT
Mismatch

IR Sync

    OK

Control Panel

Six membrane switches on the control panel are used 

to set up the transmitter by navigating the menus on 

the LCD and selecting the desired values.

Power Button

Side Button 

Setup Switch

Modulation 

LEDs

Previous 

Screen

UP/DOWN Buttons for 

Menu Item Selection

Enter Menu and 

Select Item

IR Sync Port

Setup and Adjustments

Powering On

Press and hold the 

Power Button

 for several seconds 

until a countdown on the LCD is completed. The 

countdown from 1 through 3 will appear on the LCD, 

followed by a display of the model, firmware version, 

frequency block and compatibility mode.

Hold

for

Rf On

...3

HH
V1.00

Blk  24

Hybrid

When you release the button, the unit will be opera-

tional with the RF output turned on and the 

Main 

Window

 displayed.

5

623.400

-40

-20

0

A

The Main Window

NOTE:  If the 

Power Button

 is released before the 

countdown is completed, the unit will boot up in 

the “standby” mode with the RF output turned off.