Lectrosonics HH/E01, Instruction Manual

Hand Held Transmitter

Rio Rancho, NM

7

Control Panel

Six membrane switches on the control panel are 

used to set up the transmitter by navigating the 

menus on the LCD and selecting the desired values.
The IR SYNC port is reserved for future use with IR 

enabled receivers. These receivers are not available 

as of the date of this writing.

Power Button

Side Button 

Setup Switch

Modulation 

LEDs

Previous 

Screen

UP/DOWN Buttons for 

Menu Item Selection

Enter Menu and 

Select Item

Powering On

Press and hold the 

Power Button

 for several seconds 

until a countdown on the LCD is completed. The 

countdown from 1 through 3 will appear on the LCD, 

followed by a display of the model, firmware version, 

frequency block and compatibility mode.

Hold

for

Rf On

...3

HH
V1.00

Blk  24

Hybrid

When you release the button, the unit will be opera-

tional with the RF output turned on and the 

Main 

Window

 displayed.

5

623.400

-40

-20

0

A

The Main Window

NOTE:  If the 

Power Button

 is released before 

the countdown is completed, the unit will boot 

up in the “standby” mode with the RF output 

turned off.

Powering Off

Press and hold the 

Power Button

 for several seconds 

and observe the countdown on the LCD. The count-

down on the LCD will progress from 3 to 1 and the 

power will then be turned off. This can be done from 

any menu or screen.

Powering

  Off . . .

1

NOTE:  If the 

Power Button

 is released before 

the countdown is completed, the unit will 

remain turned on and the LCD will return to 

the same screen or menu that was displayed 

previously.

Standby Mode

A brief push of the 

Power Button

 turns the unit on 

and places it into a “standby” mode (not transmit-

ting). This allows the transmitter to be set up without 

the risk of creating interference for other wireless 

systems that are operating in the vicinity.
A notice will appear briefly confirming that the RF 

output of the transmitter is turned off, followed by the 

Main Window. 

A symbol will blink as a reminder that 

the RF output is turned off.

Rf
Off

5

623.400

-40

-20

0

A

MUTE

Symbol blinks 

when RF output 

is turned OFF

With the unit turned on, a brief push of the 

Power 

Button

 will reveal a menu allowing you to choose 

between 

Resume

, 

Rf On?

, and 

Pwr Off?

. Use the 

UP/DOWN buttons to select one of these menu 

items, then press the 

MENU/SEL 

button to confirm 

this action.

Resume

Rf On?

Pwr Off?

• 

Resume: 

 Continue operating in the same con-

dition as before.

• 

Rf On?:

  Begin transmitting the RF signal.

• 

Pwr Off?:

  Turns off the transmitter.

The unit can also be turned off from any menu or 

screen on the LCD by holding the power button in for 

the duration of the countdown.