LED Direct SL8456, Manual

P7

Install lamp body of the middle run

1.Install ceiling lamp into profile slot of the 
middle run lamp;
2.Insert female connector of the first middle 
run  into the male connector of the first run ; 
and insert female connector of the next 
middle run into male connector of previous 
middle run;
3.Fasten the screws on joining with screwdriver; 
4. Splicing quantity
 When input voltage is 110V, N*P 

<

1500W

 When input voltage is 277V, N*P 

<

3600W

 N is total run, and P is power of single lamp

Install lampbody of the end run

1.Snap the clamp of suspendent rope into 
slot of lamp profile;
2.Insert  female connector of end run into 
male connector of previous run;
3. Fasten the screws on joining with 
screwdriver.

Ceiling Installation Instructions of SL8456

Exploded drawing of the first run

BOM

1. end cap of  inlet  wire     1pc

2. 8456 lamp

1pc

3. 4*25PA screw

2pcs

4. clamp

2pcs

5. rubber plug

2pcs

6. input wire

1pc

Exploded drawing of the middle run

BOM

1.8456 lamp           1pc

2.4*25PA screw      2pcs

3.clamp                    2pcs

4.rubber plug          2pcs 

33

″

(reference dimension)

Installation diagram

Exploded drawing of end run

BOM

1. 8456 end cap

1pc

2. 8456 lamp

1pc

3. 4*25PA screw

2pcs

4. clamp

2pcs

5. rubber plug

2pcs

Installation drawing for “+”shape lamp

Installation drawing for "L“ shape lamp

Kansas City:  735 Southwest Blvd Ste B • Kansas City, KS  66103  |   913.912.3760

   www.LED-KC.com   

Wichita:  327 N Hydraulic Ave, Ste 100 • Wichita, KS  67214 |   316.712.7614

   www.LED-Wichita.com