Irr
tü
m
er u
nd Ä
nd
er
un
ge
n v
or
be
ha
lte
n.
|
Er
ro
rs a
nd t
ec
hn
ic
al c
ha
ng
es e
xc
ep
te
d. | S
ou
s r
és
er
ve d
’e
rr
eu
rs e
t d
e m
od
ifi
ca
tio
ns
. | S
uj
et
o a c
am
bi
os y e
rr
or
es
. | T
ut
te l
e m
od
ifi
ch
e o e
ve
nt
ua
li e
rr
or
i r
is
er
va
ti.
8 | BA CENALED SPOT AC Gelenkkopf . BA 04/2022
2 | For safe operation
The operating parameters of the LED luminaire specified on the type plate must correspond to the supply parameters of
the connection.
Operate the luminaire only in a mounted status.
Under no circumstances may the luminaire be covered with cloths, foils or similar. Object
distance the light-emitting surface should be at least 10 cm.
When using the LED luminaire in a supply network with 220-240V AC low voltage, make
sure that the running of cables is correctly. Supply fluctuations plus xtreme surge voltages
and burst voltages can destroy LED modules, especially in the neighbourhood of large
electrical loads.
Hot plugging should be avoided, since this can lead to the destruction of the LED luminaire.
3 | Safety information
Installation of electrical equipment may only be carried out by qualified electricians.
Follow the five safety rules according to DIN VDE 1005.
Failure to do so may result
in damage to the LED luminaire, as well as fire or other hazards.
Danger of electric shock!
Disconnect before working on the device or load. Ensure to disconnect all circuit breakers
that supply dangerous voltages to the device or load, when doing so. Even when the
device is switched off, the load is not galvanically isolated from the mains.
Only use the device if it is completely free of faults, and with safety and awareness in
mind. If warnings or symbols are attached to the luminaire, they must not be removed.
4 | Assembly / Mounting
Check the LED luminaire before installation to ensure it is complete and shows no signs of damage. Do not use the
luminaire or accessories if they are damaged, as there is a risk of injury.
The LED luminaire comes fully assembled. The luminaire is mounting at the screw-on base with four screws M6 (in
delivery scope). As option there are this mounting accessories:
Product no.
Permanent Holding Magnet CENALED screw-on base
220500-01
Table clamp CENALED screw-on base
220500-02
Wall angle bracket CENALED screw-on base
220500-03
When mounting the luminaire, make sure that the luminaire is fastened securely and
stably. If the luminaire falls down, its weight poses a risk of injury!
