10 | BA INROLED_70 24V DC . BA 05/2020
5 | Connection
Suitable connection material, cables and accessories can be found in the accessory
range of LED2WORK.
The luminaire have to connected via a suitable cable.
Connection of the light may
only be carried by a qualified electrician!
1. Undo plastic nut of cable connection.
2. After undo the 3 screws of the connection side of luminaire, you can take off the end
cover with the cable connection.
3. Insert the connection cable with the open ends.
4. Install cable end according to the drawing of this WAGO terminal.
5. After the correct installation, put on the end cover and screw
it together again.
Pay attention of a correct seat of the seal
and tight the srews handtight only!
Do not use an electric screwdriver!
The luminaire is not equipped with a switch. Usually you switch ON or OFF the luminaire
via an external switch.
4 | Assembly / Mounting
Check the LED luminaire before installation to ensure it is complete and shows no
signs of damage. Do not use the luminaire or accessories if they are damaged, as
there is a risk of injury.
The LED luminaire comes fully assembled. The luminaire can mounted via optional
mounting hardware:
Item no.
INROLED_70 luminaire holder, aluminium, pair
210200-02
When mounting the luminaire, make sure that the luminaire is
fastened securely and stably. If the luminaire falls down, its weight
poses a risk of
injury!
Through-wiring: Through-wiring can be used to link several luminaires electrically to
one another. The total current consumption must not exceed 4A DC at ta max. +35°C.
