34
4.
Repeat the above steps as often as necessary remembering to rub gently rather than to
“scrub” the rollers.
5.
Plug in and turn on the laminator. Use your reverse switch to slightly rotate the laminating
rollers to provide access to a new, un-cleaned section. The pull rollers can be rotated by
hand to a new position.
WARNING: NEVER CLEAN THE ROLLERS WHILE THEY ARE TURNING. The
rollers may catch your fingers and cause injury, or they may catch your cleaning materials
and damage the laminator. UNPLUG THE POWER CORD WHILE CLEANING THE
ROLLERS OR PERFORMING OTHER MAINTENANCE ON THE MACHINE. TURN
THE ROLLERS BY HAND.
6.
Repeat above steps as often as necessary until cleaning is complete.
The pull rollers should also be cleaned in the same manner.
TURN OFF and UNPLUG THE
MACHINE
. The pull rollers are easier to clean because they are more accessible, and because
they should not have any adhesive on them. Be sure to reposition and secure the upper heat
rollers before beginning to laminate.
6-4 LUBRICATION
Drive Gears
The drive gears should receive a light coating of lithium grease after each 500 hours of
operation. The drive gears are located inside the left hand machine enclosure.
Always disconnect
power before removing this enclosure cover plate and do not operate the machine until it has
been properly reinstalled.
