background image

Congratulations on your choice of LEDX Lights headlamp 

You have chosen a quality product, developed and manufactured in Sweden 
for tough conditions. By using components of the highest quality and that 
you have access to our good service, means that  our products have a very 
long service life and thus a lower burden on the environment. In case of any 
problems with the product, please contact LEDX Light's service for mainte-
nance or repair. 
The lamp has been developed with a focus on good light, low weight and 
flexibility. 

Safety instructions 

Warning! 

The light from the lamp is very strong, avoid looking directly into the lamp or 
light with the lamp in your or someone else's eyes. If someone accidentally 
shines into the eyes close your eyes and move your head out of the light 
cone. Do not use binoculars or other highly focused optical product to view 
the light cone. 
If for some reason the lamp does not work, do not try to repair the lamp or 
battery yourself. Attempting to open the battery yourself is associated with 
the risk of fire or explosion. In case of any problems, contact LEDX Light's ser-
vice for advice on how to proceed with your particular product. 

Heat dissipation: 

The lamp can get very hot about + 75 ° C. If the lamp is used stationary out-
doors or indoors, after a few minutes the lamp's power is gradually reduced 
to about 50% depending on air circulation and ambient temperature. To be 
able to deliver full power, the lamp needs a continuous air circulation around 
the heat sinks through movement. Depending on the ambient temperature, 
the speed varies, but about 6 km / h can be seen as a guide value at + 20 ° C. 
The lamp has a built-in thermostat that prevents the lamp from overheating, 
it automatically lowers the power if the temperature should go above about 
+ 75 ° C, when the temperature drops the power rises again. 
The light beam also becomes very hot, the light from the lens on the lamp is 
very concentrated and can reach temperatures of over  + 100 ° C up close. Do 
not cover the lamp, eg put it in a pocket or bag with the light on, also avoid 
lighting flammable objects up close. This may cause fire or other damage. 

Summary of Contents for Cobra 6 500 X-pand









Reviews: