Important:
Always disconnect the battery when the lamp is not in use, such as during
transport or storage. This is to prevent the lamp from turning on accidentally
and slowly draining the battery. The lamp has a certain consumption, albeit
very low, even when it is switched off with connected to a battery. There is a
risk that the lamp may drain the battery of the remaining capacity and da-
mage or seriously damage the battery.
Water resistance:
The lamp and battery are weatherproof and can withstand all weather condi-
tions and water splashes, but should not be used under water or washed
with a high-pressure cleaner. Meets IP65.
Lamp
Turn on the light
Connect the battery to the lamp,
be sure that the connectors has
the LEDX logo on the same side.
Do not force the connector to-
gether the wrong way, it can
destroy the battery.
Turn on the lamp by a long press on the switch (approx. 1 sec). Switch
between power modes by short presses, switch off the lamp with a long
press. Upon delivery, the lamp is in program mode 5 which has three power
modes and it starts at a low power. The lamp then starts in the power mode
it was set to when it was turned off. If the battery is disconnected, the lamp
will start on low power again next time.
Battery
Li-Ion battery with USB-C charge and battery indicator
Before using the lamp, the battery needs to be charged. Connect the suppli-
ed charger to a 100-240V wall socket and to the USB-C socket on the battery.
Depending on the battery's capacity, charging takes 4-8 hours from an emp-
ty battery. Do not charge the battery at temperatures below + 2 ° C. Do not
store the battery with low charge, if you have 20% - 40% capacity left, you
should charge the battery within a week or so, if you have less than 20% of
the capacity left, the battery must be charged within a couple of days to avo-
id risk of damage. For long-term storage (several months or more) charge
Summary of Contents for Cobra 6 500 X-pand
Page 1: ...Cobra 6 500 X pand English...
