background image

 

 

Even the light beam gets very hot. The light from the lamp is very concentrated and can 
reach the temperatures over +100°C close to the lamp. 

Don’t cover the lamp (for ex. put 

it in a pocket or a bag) when the light is on, avoid aiming at the flammable objects when 
near them. This could cause a fire or other damage.  

NB: 

Always disconnect the battery when the lamp 

isn’t in use, for example for transportation 

or  storage.  This  is  to  avoid  the  lamp  turning  on  by  accident  and  slowly  draining  the 
battery.  The  lamp  uses  some  energy  if  connected  to  the  battery  even  when  it  is  off, 
though this energy usage is very low. There is a risk that the lamp can drain the battery 
and destroy or seriously damage it.  

 

 

 

 

Water resistance: 

The lamp and the battery are weathertight and can withstand all weather conditions and 
water splashes, but it 

shouldn’t be used under the water or washed with a high-pressure 

cleaner. Meets IP65. 

 

 

The lamp 

Turn the lamp on 

Connect the battery to the lamp, turn the lamp on by holding the switch-on button 
(appr. 1 sec). Switch between effect modes by clicking the button, turn the lamp off 
by holding the button. The lamp is in programme 5 with 3 effect modes and starts 
with the lowest effect when delivered. Later the lamp starts in the effect mode which 
was used when the lamp was switched off. If the battery is disconnected the lamp 
will start at the low effect the next time it is switched on.

 

 

The lamp can easily be tilted up or down, it could feel a bit stiff when the lamp is new. 
Usually, it is best to aim the lamp so the light goes straight forward, thus the lens and the 
reflector distribute the light and you get the right amount of it where you need it.  

 

Burning time 

The table below shows the approximate burning times with the standard battery. The 
lamp can be complemented with the LEDX Lights batteries with higher capacity if 
longer burning times are desired. (Available from Feb 2022).

 

Programmed modes and power usage as well as burn time for different modes apply to 
fully a charged battery and at appr. 20°C. 

Summary of Contents for Snock 2000










Reviews:

Related manuals for Snock 2000