Figure 3: Handle sockets should face each other.
Abrasive Side Out
Handle Socket
Figure 4: Inserting the beam.
Distributed by / Distribué par
Lee Valley Tools Ltd. Ottawa ON K2H 1C2 Canada leevalley.com
© Lee Valley Tools Ltd. 2019
1242 INS-715_A
Position the two handles as shown in
Figure 3
, such that the handle sockets
are facing each other.
Insert one end of the beam into one of the handle sockets, and then fl ex the
beam to insert the other end into the other handle socket.
To increase the tension, use a shorter length of sandpaper. To reduce it, use a
longer strip of sandpaper.
Flex the beam to disengage it from the handles and remove the sandpaper.
