SN-L+ USER MANUAL
9
②
The vibration is large, and most of the vibration points fall outside the warning line, which easily leads to the FC
can’t calculate the correct attitude
CALIBRATE LEVEL
<SENSOR>-<CALI LEVEL>
①
Ensure that the aircraft is level and static during horizontal calibration.
②
Horizontal calibration is required after changing the mounting direction.
③
If you have not calibrated for a long time or the temperature difference has changed too much, you need to
recalibrate.
SENSITIVITY ADJUSTMENT
①
<
BASE FUNCTION
>-<
AIL BASE GAIN
> -<
ELE BASE GAIN
> -<
RUD BASE GAIN
>
:
The larger the value, the faster the reaction speed
and the excessive jitter.
②
<
BASE FUNCTION
>-<
FEED FORWARD GAIN
>:
The larger the value, the faster the response joystick will be, and the jitter
will be exceeded.
③
Adjustment Steps:
Step1：
set
<FEED FORWARD GAIN>
,
normally reduce feed forward gain to 45
Step2：
set the
<
AIL BASE GAIN
> -<
ELE BASE GAIN
> -<
RUD BASE GAIN
>.
You can fly by default, then increase or decrease the
sensitivity according to the state of flight.
④
PID speed Factor
PRINCIPLE
:
the faster the speed, the smaller the rudder surface sensitivity should be.
The greater the value, the greater the speed
involved in PID control.
EXAMPLE
:
when speed of the aircraft is very fast, the aircraft begins to shake; then you can increase
<ADVACE FUNC>-<STAB
GAIN>-<SPEED PID FACTOR>
value.
⑤
Altitude hold gain
<
ADVANCE FUNC
>-<
STAB GAIN>-<ALT HOLD GAIN
>
IN RTH，ALT-HOLD, WAY-POINT mode, if aircraft action like this in the pitch direction:
please decrease alt-hold gain.
8. FLIGHT & CONTROL
AUTO TAKEOFF：
①
AltHold mode：Push the throttle to enough power and the aircraft will automatically climb to a height of 20m.
②
RTH mode:
Way1: push throttle channel away from the zero position, give plain a speed until motor start.
Way2: push throttle channel away from the zero position, shake the aircraft, until motor start. Aircraft will auto climb at 30m.
