2.2 Change of Frequency
The system works by factory setting at frequency channel 1 (910.00MHz). In rare cases it may be useful to change the
frequency channel because the actual one is occupied by other radio devices.
This can be done by pressing simultaneously at least 3 seconds push button 1 “ENABLE” and push button 4 “STOP”.
If this setting mode is enabled the red LED (2) turns on. The green LED and the buzzer are signalizing the chosen
frequency channel according the following table:
Flash / Beep
Parameter
Frequency
1 x
Frequency channel 1
910.000 MHz
2 x
Frequency channel 2
910.300 MHz
3 x
Frequency channel 3
910.600 MHz
4 x
Frequency channel 4
910.900 MHz
Each time the push button 1 „ENABLE“ is pressed the setting will change to the next frequency channel.
The push buttons 2 “UNLOCK” and 3 “LOCK” do not have any function in this mode.
By pressing the push button 4 „STOP“ this configuration mode will be left or automatically after 15 seconds of no
manipulation and the selected frequency channel is stored.
The receiver needs not to be changed. It will automatically synchronize to the selected transmitter frequency.
2.3 Technical Details
Frequency:
channel 1: 910.000 MHz (factory setting)
channel 2: 910.300 MHz
channel 3: 910.600 MHz
channel 4: 910.900 MHz
Supply:
4,5 V DC / 3 alkaline batteries, type AAA
Dimension:
120x70x30mm
Manipulation:
4 push buttons
- 2 x ENABLE within 0.5 s enables UNLOCK for 2 seconds
- LOCK is at any time usable
- UNLOCK within 2 seconds after enabling possible
- STOP cancels any active lock or unlock function
Display:
10 LEDs -
green flashing
: lock function is active
-
green 10s on
: all limit switches of lock function are closed
-
red flashing
: unlock function is active
-
red 10s on
: all limit switches for unlock function are closed
-
green and red are flashing alternatively:
error signalized
-
yellow transmitter on:
handheld transceiver is active and battery state is ok
- yellow transmitter flashes
: handheld transceiver is active and
- yellow receiver off (while device is active):
receiver supply voltage ok
- yellow receiver flashes:
receiver supply voltage is low
-
blue 1-6 limit switch:
show state of each limit switch during lock- or unlock function
