3.2 Teach in handheld transceiver
If a new or supplementary handheld transceiver shall be used, it has to be teached into the receivers memory.
By pressing the push button “LEARN” while the receiver is in its normal operation mode, the device will change into a
learn mode. This is displayed by an on state of the LED “LEARN/FUNCTION”.
Now the lock function may be activated at the handheld transmitter which one shall work together with the receiver.
After having learned the transmitters address, the receivers LED “LEARN/FUNCTION” switches off.
A maximum of 8 different handheld transceiver addresses may be learned by each receiver. So, if you try to teach in the
9
th
address, the LED “LEARN/FUNCTION” flashes slowly 3 times to signalise the non accepted new device.
In this case all learned addresses must be erased. Therefore press the push button “LEARN” once, as you do for
entering into the learn mode and then press again and hold the same pushbutton for at least 5 seconds.
The learn mode will then be left automatically.
If the learn mode has been activated accidentally without teaching in a transmitter, it will be left automatically after 30
seconds.
3.3 Technical details
Frequency:
one of the frequency channels is automatically selected, depending on the transmitters
frequency
channel 1: 910.000 MHz
channel 2: 910.300 MHz
channel 3: 910.600 MHz
channel 4: 910.900 MHz
Dimension:
255mm x 180mm x 95mm
Supply:
24V DC,
without reverse polarity protection!
Limit switch inputs:
18,5V to 28V (high active) with LED display at each input