22
3.6.2
Bypass Mode Setting
Enter the setting interface. Press and hold the function setting key
for more than 2
seconds, then come to setting interface, Press and hold the function setting key
for more
than half a second(less than 2 seconds), select the function setting, choose the bypass output
interface, at the moment, the letters “BPS” will flash.
Enter the Bypass output selecting interface. Press and hold the function setting key
for
more than half a second(less than 2 seconds), then come to setting interface of BPS, at this
time, the letters “BPS” will light for a long time. The “ON” letter will flash. Press and hold the
inquiring key
（
,
）
for more than half a second (less than 2 seconds) to determine
whether the BPS function is used or not. If used, the corresponding word is “ON”, if not, the
word is “OFF”. It can be determined by yourself.
Confirm the Bypass output selecting interface. After selecting ON or OFF, press and hold the
function setting key
for more than half a second (less than 2 seconds), Now, the BPS
setting function is completed and the “ON” or “OFF” will light without flash.
Press and hold function setting key
for more than 2 seconds, exit from the setting
interface and return to main interface.
After setting BPS as ON, when mains power plugged in without turning on the UPS or no mains
power plugged in, there is bypass output but no power down backup function.
25 %
50 %
75 %
100 %
25%
50 %
75 % 100%
VAC
HZ
INPUT
25%
50 %
7 5% 100%
25%
50%
75 %
100 %
Summary of Contents for 10KVA
Page 1: ...USER MANUAL RACK UPS 1 10 KVA ...
Page 2: ...2 ...
Page 3: ...3 USER MANUAL Rack Series 1 10 KVA ...
Page 44: ......
