14
Mode).
4.4 Single UPS turn On/Off operation
4.4.1 Turn on operation
> Turn on the UPS on line mode
①
Once mains power is plugged in, the UPS will charge the battery, at the moment, LCD shows that the output
voltage is 0, which means UPS has no output as default condition. If it is expected to have output of bypass,
you can set the BPS “ON” by LCD setting menu.
②
Press and hold the ON key for more than half a second to start the UPS, then it will start the inverter.
③
Once started, the UPS will perform a self-test function, and LED will light and go off circularly and orderly.
When self-test finishes, it will come to online mode, the corresponding LED lights, UPS is working in line
mode.
> Turn on the UPS by DC without mains power
①
When main power is disconnected, press and hold the ON key for more than half a second to start UPS.
②
The operation of UPS in the process of start is almost the same as that when mains power is on. After the
self-test finishes, the corresponding LED lights and UPS are working in battery mode.
4.4.2 Turn off operation
> Turn off the UPS in line mode
①
Press and hold the OFF key for more than half a second to turn off the UPS and inverter.
②
After UPS shutting down, LED goes out and there is no output. If output is needed, you can set BPS “ON”
on LCD setting menu.
> Turn off the UPS in DC mode without mains power
①
Press and hold the OFF key for more than half a second to turn off the UPS.
②
When turning off the UPS, it will do self-test first. LED lights go out circularly and orderly until there is no
display on the panel.
4.5 Single UPS self-test/mute test operation
①
When UPS is in LINE Mode, press and hold the self-test/mute key for more than 1 second, LED light will go
off circularly and orderly. UPS comes to self-test mode and tests its status. It will exit automatically after
finishing test.
②
When UPS is in BAT Mode, press and hold the self-test/mute key for more than 1 second, the buzzer stops
beeping. If you press and hold the self-test/mute key for one more second, it will restart to beep again.
4.6 Single UPS panel function setting
UPS has setting function. It can run the setting in any mode. After setting, it will become effective at once
when meets some standards. The set information can be saved only when the battery connected and
normally turning off the UPS.
4.6.1 ECO mode setting
①
Enter the setting interface. Press and hold the function setting key
for more than 2 seconds, then come
to setting interface, press and hold the inquiring key (
,
)
for more than half a second(less than 2
Summary of Contents for 3106
Page 2: ...1 ...
