4
FRONT AND REAR PANEL DESCRIPTIONS
1. Battery/Surge Outlets
Provides four battery powered/surge outlets for connected equipment and insures temporary
uninterrupted operation of your equipment during a power failure.
2. Power Switch
Can be used as a mater on/off switch for equipment connected to the battery power supplied outlets.
3. Power On Indicator
This LED is illuminated when the utility condition is normal and the UPS outlets are providing power,
free of surges and spikes.
4. Electrical Wiring Fault Indicator
This LED indicator will illuminate to warn the user that a wiring problem exists, such as bad ground,
missed ground or reversed wiring. If this is illuminated, disconnect all electrical equipment from the
outlet and have an electrician check to ensure the outlet is properly wired.
5. Circuit Breaker
Located on the side of the UPS, the circuit breaker serves to provide overload and fault protection.
Under normal operating conditions, the circuit breaker is depressed.
6. Serial Port to PC
This port allows connection and communication from the DB-9 serial port on the computer to the UPS
unit. The UPS communicates its status to the PowerPanel™ software. This interface is also
compatible with the UPS service provided by Windows NT Windows 2000, and Windows XP.
7. Communication Protection Ports
Communication protection ports will protect any standard modem, fax , telephone line, or network
cable.
8. Outlets Designed for AC Adapters
Allows six AC power adapter blocks to be plugged into the UPS without blocking adjacent outlets.
