www.connectinglegacy.com
- 11 -
5.3.Installing the Battery Pack
5.3.1.Mounting to a wall
WARNING
In order to avoid electrical shock or other injury, inspect existing electronic or plumbing installations before drilling holes.
The battery is heavy, please handle with care to avoid damage to the product or injury to the installer.
1.Choose suitable firm wall with thickness greater than 80mm.
2.Use the mounting frame as a template, mark the hole position.
3.Drill 8 holes according to the hole position, it is ø10 with depth 60mm.
4.Hammer the M8 screws to the above holes, and screw the nut. Note: Do not position screws flush to
the wall - leave 10 to 20 mm exposed.
5.Fix the mounting frame to the 8 screws.
6.Raise the battery a little higher than the mounting frame whilst maintaining the balance of the battery.
Hang the battery on the frame through the match hooks.
WARNING
Falling equipment can cause serious or even fatal injury: never mount the inverter on the bracket unless you are sure that
the mounting frame is firmly mounted on the wall after thorough checking.
5.4.Parallel use of battery
When the battery needs to be used in parallel, the maximum connection is 10units, but we recommend
to use 2-4 units according to application. The application needs power and communication connections
as below, choose suitable accessories:
