9
In support of our policy of continuous product improvement we reserve the right to change materials and specifications without notice. Drawings, where used, are not to
scale. All dimensions are in millimetres and sizes given are approximate. Where possible, technical MSDS data sheets are made available on the website. All products
should be installed and used in accordance with manufacturer’s instructions provided. Warning: products may be the subject of registered designs and patents. Refer
to website for terms and conditions on warranty.
The Cable cannot be cut:
A. Tool Blades are worn or damaged. The blades must be replaced. Tools with
worn or damaged blades might cause property damage or even personal
injuries.
B. Applied cable is over-specification. Please check the specification table. The
circuit breaker will need to be reset.
C. The blade might be deformed by uneven distribution after cutting an
off-center cable.
Charging Lamp does not light up:
A. Dust, etc. has entered the battery cartridge. Clean the battery to remove any
obstructions.
B. Battery cartridge is overheating. Allow the cartridge to cool before
conditioning.
Even fully charged, the cutting capacity is reduced:
A. Life of the battery has expired. Replace the battery with a new battery
pin MSS-BL1430B
B. Deterioration of the blade. Replace the blade with a new blade.
Tool does not operate:
A. Battery cartridge is not charged. Charge the battery cartridge.
B. The battery contacts are dirty. Clear the battery contacts of dirt or debris.
C. The circuit breaker has been actuated. Push the reset pin to reset the circuit
breaker back to its original position
D. The OFF lock is not fully depressed. Make sure it is fully depressed and
reset the circuit breaker if necessary.
Trouble - Shooting
