6
In support of our policy of continuous product improvement we reserve the right to change materials and specifications without notice. Drawings, where used, are not to
scale. All dimensions are in millimetres and sizes given are approximate. Where possible, technical MSDS data sheets are made available on the website. All products
should be installed and used in accordance with manufacturer’s instructions provided. Warning: products may be the subject of registered designs and patents. Refer
to website for terms and conditions on warranty.
3. Please find below diagram regarding on the safety switch.
The safty switch need to be press in the same time when you press the
trigger to make the blade moving, once the blade move, then the finger
press on the safety switch can be remove.
4. When the tool is sitting idly or once you are finished with it, put the tool
switch in the central position.
ATTENTION
Keep your fingers away from edge of the
moving blade when feeding it into the
gear mechanism. The switch may have
moved from the NEUTRAL position.
6
3. Please find below diagram regarding on the safety switch.
The safty switch need to be press in the same time when you press the
trigger to make the blade moving, once the blade move, then the finger
press on the safety switch can be remove. Picture it shows the cutter stay in Neutral.
4. When the tool is sitting idly or once you are finished with it, put the tool
switch in the central position.
ATTENTION
Keep your fingers away from edge of the
moving blade when feeding it into the
gear mechanism. The switch may have
moved from the NEUTRAL position.
Safety Instructions
Follow ALL instructions to ensure safety.
WARNING
ATTENTION
Read all instructions, warnings, and
cautions carefully. Follow all safety
precautions to avoid personal injury
or property damage.
Thank you for using
KuDos® products. This manual must be read
carefully prior to operating this product. Special attention should be paid
to the section “Safety Instructions”. Damages and injuries caused by
improper use of this product are
NOT included in our warranty. We
would like to remind you to work safely and to keep this manual on hand.
Always wear safety goggles when
operating this product. Projectiles or
hydraulic fluid can cause serious
injuries.
This product is
NOT an insulator and
cannot be used near energized
conductors.
Do not use this tool on glass, plastic,
wood or any other materials which
could shatter.
Do not exceed
equipment ratings.
1
