INSTALLATION INSTRUCTIONS
Fixing Holes
Remove the fire trim and position the fire in the desired
location secure the fire to the wall, using suitable fixings
in the six fixing holes provided in the fire flange, an anti-
tilt bracket is fitted to the top of the fire to be used when
fitting in an existing fireplace, when secure re-fit the fire
trim and place the lose coals, pebbles onto the coal
support as shown.
Note
If the fire is being used in an existing fireplace, it is
important that the chimney is blocked off to prevent
downward draughts and falling debris. This can be
achieved by inserting mineral wool into the chimney and
covering with a piece of board into the chimney opening
above the appliance.
Anti-tilt
Bracket
Pebbles
