Janu
ary 201
9
Legrand PDU User Guide 213
System Tamper Alarm:
This action causes the Legrand PDU to show the alarm for the DX tamper sensor, if any, on the
Dashboard page until a person acknowledges it. By default, this action has been assigned to the built-in
tamper detection event rules. For information on acknowledging an alarm, see
Dashboard - Alarms
(on
Actions you can create:
1. Choose Device Settings > Event Rules >
.
2. Click the Action field to select an action type from the list.
3. Below is the list of available actions.
Note: The "Change load shedding state", "Power control server" ,and "Switch outlets" options are only
available for outlet-switching capable models.
Action
Function
Alarm
Requires the user to acknowledge the alert
after it is generated. If needed, you can have
the alert notifications regularly generated until
a person takes the acknowledgment action.
See
Alarm
Change load
shedding state
Enters or quits the load shedding mode. See
Change Load Shedding State
(on page 214).
Execute an action
group
Creates a group of actions comprising existing
actions. See
Action Group
(on page 214).
Log event message
Records the selected events in the internal log.
See
Log an Event Message
(on page 214).
Power control server Two operations are available.
Shuts down a monitored server and then
powers off the outlet(s) associated with that
server.
Powers up the outlet(s) associated with a
monitored server.
See
Shut down a Server and Control its
Power
(on page 215).
Push out sensor
readings
Sends internal sensor log or environmental
sensor log to a remote server using HTTP
POST requests. See
Push Out Sensor
Readings
Record snapshots to
webcam storage
Makes a connected webcam start or stop
taking snapshots. See
Record Snapshots to
Webcam Storage
(on page 215).
Send email
Emails a textual message. See
Send Email
(on page 216).
Send sensor report
Reports the readings or status of the selected
sensors, including internal or external sensors.
See
Send Sensor Report
(on page 217).
