Janu
ary 201
9
Legrand PDU User Guide 85
2. Examine your Legrand PDU and the connected equipment to remove or resolve the cause that results in
the overload or short circuit.
This step is required, or you cannot proceed with the next step.
3. Press the ON button until it is completely down.
Resetting the Handle-Type Circuit Breaker
Your handle-type circuit breakers may look slightly different from the images shown in this section, but the
reset procedure remains the same.
To reset the handle-type breakers:
1. Lift the hinged cover over the breaker.
2. Check if the colorful rectangle or triangle below the operating handle is GREEN, indicating that the
breaker has tripped.
3. Examine your Legrand PDU and the connected equipment to remove or resolve the cause that results in
the overload or short circuit.
This step is required, or you cannot proceed with the next step.
4. Pull up the operating handle until the colorful rectangle or triangle turns RED.
