Janu
ary 201
9
Legrand PDU User Guide 177
a. Select the 'Enable SNMP notifications' checkbox.
b. Select a notification type -- SNMPv2c trap, SNMPv2c inform, SNMPv3 trap, and SNMPv3 inform.
c. Specify the SNMP notification destinations and enter necessary information. For details, refer to:
SNMPv2c Notifications
(on page 288)
SNMPv3 Notifications
(on page 289)
Note: Any changes made to the 'SNMP Notifications' section on the SNMP page will update the settings
of the System SNMP Notification Action, and vice versa. See
Available Actions
(on page 211). To add
more than three SNMP destinations, you can create new SNMP notification actions. See
Send an
SNMP Notification
(on page 219).
5. You must download the SNMP MIB for your Legrand PDU to use with your SNMP manager.
a. Click the Download MIBs title bar to show the download links.
b. Click the PDU2-MIB download link. See
Downloading SNMP MIB
(on page 291).
6. Click
Save.
Configuring SMTP Settings
The Legrand PDU can be configured to send alerts or event messages to a specific administrator by email.
See
Event Rules and Actions
(on page 199).
To send emails, you have to configure the SMTP settings and enter an IP address for your SMTP server and
a sender's email address.
If any email messages fail to be sent successfully, the failure event and reason are available in the event log.
See
Viewing or Clearing the Local Event Log
(on page 259).
To set SMTP server settings:
1. Choose Device Settings > Network Services > SMTP Server.
2. Enter the information needed.
Field
Description
IP Address/Host
Name
Type the name or IP address of the mail server.
Port
Type the port number.
Default is 25
Sender Email
Address
Type an email address for the sender.
Number of Sending
Retries
Type the number of email retries.
Default is 2 retries
Time Between
Sending Retries
Type the interval between email retries in minutes.
Default is 2 minutes.
Server Requires
Authentication
Select this checkbox if your SMTP server requires
password authentication.
