2/16
ELIOT Kit STOP&GO Connected
Cat. N°: 4
149 54
3. OVERALL DIMENSIONS
(continued)
. Wi-Fi interface module (already equipped with an external Half
Wave 2.4GHz Antenna With RP-SMA Connector):
. Power supply module:
. Supply patch cord:
L = 250 mm
4. PREPARATION - CONNECTION
Fixing:
. On symmetric rail EN/IEC 60715 or DIN 35.
Operating positions:
. Vertical, Horizontal, backwards, on the side
Power Supply:
Primary voltage 95÷250 V~
Secondary voltage 12 VDC 500 mA
. Power distribution towards the interface via specific 250 mm supply
patch cord (delivered with the kit) to connect at the downstream of
the supplier indifferently in one of the two dedicated ports
Supply of the Wi-Fi Interface:
. Mandatory in 12 VDC via the specific Power supply module and
specific supply patch cord 250 mm length (delivered with the kit) to
connect at the downstream through dedicated port
Supply of the Stop&Go:
. Supply Phase and Neutral from the top on the extractable
connector.
. It is mandatory to connect Phase and Neutral downstream of the
associated device and the protection conductor to the connector at
the bottom of this device. Stop&Go will not work correctly if the
protection conductor is not connected.
Technical data sheet: F02465EN/01
Updated: 28/03/2019
Created: 06/10/2016
Connection cable to
the Stop&Go
