50
5.5.7 Detect
In the MAIN MENU -> SETTING -> DETECT, you can see motion detection interface. You can see in the dropdown list three
detection types:
- Motion Detect,
- Video Loss,
- Camera Masking.
1) Motion Detection
Analysis the video, system enable motion detection alarm when it detects the motion signal reached the specified sen-
sitivity.
DETECT menu is shown below.
1 - Event type:
From the dropdown list you can select Motion Detect.
2 - Channel:
Select the channel to activate recording function when an alarm occurred.
Please make sure you have set “MD” record in schedule interface
(MAIN MENU -> SETTING -> SCHEDULE) and set “schedule” record in record interface
(MAIN MENU -> ADVANCED -> RECORD).
3 - Region:
Click on “Select” button, a pink screen appears, pink zone is the motion detection zone.
Black zone is the disarmed zone. There are 396 small zones.
- With the mouse: you can deselect the motion detection area.
- With the front panel: here you can set motion detection zone. The green zone is current cursor position. Pink
zone is the motion detection zone. Black zone is the disarmed zone. You can click on the “Fn” button to switch
between the arm mode and disarm mode. In arm mode, you can click on the direction buttons to move the green
rectangle to set the motion detection zone. After you completed the setup, please click on “ENTER” button to exit
current setup. Do remember click on the “Save” button to save current setup. If you click on “ESC” button to exit
the region setup interface system will not save your zone setup.
4 - Sensitivity:
System supports 6 levels. The sixth level has the highest sensitivity.
