SYSTEM INSTALLATION & TYPICAL APPLICATIONS
1. System Installation
Keyboard Installation
Before you start connecting the keyboard equipment to your system, make sure the units to be controlled are completely
installed and everything is working correctly. Before use of this keyboard, you should set the protocol and baud rate
(2.4~57.6kbps) in the PTZ SETUP mode.
Use the following steps to set the communication protocol and baud rate.
2. PTZ SETUP
PTZ SETUP
PTZ Setup mode, select 1+
, (2~3 seconds) setup screen allows you to make change ench programmable
clause.
Note: The baud rate must be the same between the controlled unit and the keyboard.
SAISIE DU MOT DE PASSE (4 CHIFFRES)
REGLAGE DE L
’
ADRESSE (1-225) + ENT.
REGLAGE DU MODELE (WDS/WCY/CYN/WSL/Pelco)
REGLAGE DU PROTOCOLE (PEL-D/PEL-P/W-DRX)
REGLAGE DU DEBIT (2,4-57,6 KBPS)
REGLAGE DE LA PARITE (AUCUNE/PAIRE/IMPAIRE)
PROP. (ON/OFF) : commande de vitesse proportionnelle
SAUVEGARDE DES DONNEES DE CONFIGURATION
QUITTER LE MENU
CHANG. DE NIV. DE MENU DE CONFIG.
Ex_ cution de la commande
CONFIG. PTZ
MOT DE PASSE
CONFIG. PTZ
1. ADRESSE: 001
CONFIG. PTZ
2. MODELE : PEL
CONFIG. PTZ
3. PROTOCOLE: PEL-D
CONFIG. PTZ
4. DEBIT: 2,4 K
CONFIG. PTZ
5. PARITE: NON
CONFIG. PTZ
6. PROP: ON
CONFIG. PTZ
7. SAUVEGARDE
CONFIG. PTZ
8. QUITTER
CONFIG. PZT
[PTZ SETUP 1]
PASSWORD [****]
[PTZ SETUP 1]
1. ADDRESS : 001
[PTZ SETUP 1]
2. MODEL : PEL
[PTZ SETUP 1]
3. PROTOCOL : PEL-D
[PTZ SETUP 1]
4. BAUDRATE : 2,4 K
[PTZ SETUP 1]
5. PARITY : NONE
[PTZ SETUP 1]
6. PROP. : ON
[PTZ SETUP 1]
7. SAVE
[PTZ SETUP 1]
8. EXIT
PTZ SETUP
Input password (Factory set : 0000)
: Input camera address by using joystick
(1~255) + ENT
: Find the camera model which user want to control by using joystick
Choose “CMT”
: Set the protocol. Choose “PEL-D”
: Set the baudrate (2,4KBPS - 57,6KBPS)
Choose “2,4KBPS”
: Set the PARITY (NONE/EVEN/ODD)
Choose “NONE”
: Set the camera speed
Slow PTZ => PROP : ON
Speed PTZ => PROP : OFF
Choose “ON”
: Save the data
: Exit PTZ SETUP Menu
8
