Installation Instructions
LFE1U
15
6.
Install four 5/16 x 1/2” button head cap screws (X) through
slots on wall brackets (B1) and side of column assembly (P).
(See Figure 25)
Figure 25
Securing with Hardware to Floor (Optional)
The LFE1U can be mounted to the floor for additional support
and security, however it CANNOT be installed to the floor ONLY
without being also attached to a wall. No hardware is provided
for supplemental mounting to the floor.
Display Installation
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the weight of all
components attached to the LFE1U does not exceed 200 lbs
(90.7 kg).
1.
Make sure height is at the lowest possible position.
2.
Make sure latching flags are in "open" position.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! DO NOT substitute
hardware. Only use hardware provided or specified by
manufacturer.
3.
Determine and mark the vertical center position between
the Left side Upper and Lower mounting holes in display.
(See Figure 26)
4.
Determine and mark the vertical center position between
the Right side Upper and Lower mounting holes in display.
(See Figure 26)
Figure 26
5.
Orient vertical mounting bracket (WR) so that mounting
holes are on top and mounting slots are on bottom. (See
Figure 26)
6.
Align mounting holes in vertical mounting bracket (WR) with
upper and lower mounting holes in display.
7.
Adjust vertical mounting bracket (WR) position until mark
made in Step 1 aligns with center mark in vertical mounting
bracket (WR).
8.
Select correct screws, nesting spacers (if necessary) and
universal washers (if required) from the hardware bag (WA-
WM) and attach brackets to back of screen. (See Figure 28)
IMPORTANT ! :
The M8 screws do
NOT
require a
washer. Use the universal washer (WMB) only with M4,
M5 and M6 screws.
NOTE:
The nesting spacers (WMA) may be used separately,
or put two together in different configurations to create
different size spacers. (See Figure 27)
Figure 27
(X) x 4
6
(P)
for 1/4" screws (not included)
for 5/16" anchors (not included)
6
3
(TR) x 2
Mounting holes
Mounting Slots
(Single)
(Nested)
(Stacked)
0.375
[9.5]
0.563
[14.3]
0.750
[19.1]
