LFE1U
Installation Instructions
18
Tilt Adjustment
IMPORTANT ! :
Remove display from mount prior to
adjusting tilt!
5.
Use 3/16" hex key (H) to remove tilt adjustment screws on
both sides. (See Figure 33)
6.
Adjust faceplate tilt and re-install removed screw in either
the middle hole for 2° tilt or the lowest hole for 4° tilt. (See
Figure 33)
Figure 33
Roll Adjustment
7.
Loosen nuts on back of faceplate. (See Figure 34)
8.
Adjust roll as desired. (See Figure 34)
9.
Tighten nuts on back of faceplate. (See Figure 34)
Figure 34
Troubleshooting
If lifting function does not work properly, try to following
troubleshooting steps. If none of these work, contact customer
service.
1.
If there is uneven movement, initialize the control box
(reset)
•
Hold "Down" button until lift has reached it’s lower
limit.
•
Briefly release "Down" button
•
Press and hold "Down" for five seconds, wait until
all movement has stopped, then release
2.
If there is no movement, check the following
•
Check all cable connectors between controllers
and actuators.
•
Check power cable connection to control box.
3.
If there is slight movement and then reverse travel, check
for any obstructions that may be interfering such as cables
or peripheral devices.
4.
Contact customer service if none of the above steps fix the
problem.
5
6
6
2°
4°
remove
re-install
(rear view)
8
7
9
